This software allows to
control the production of pu sole from the office; the supervisor pc is
located in the office and is connected by ethernet with the pc of the robot
and with the pc of the rotary table. Each mould must be provided with a
radiofrequency tag (RF-ID system idenitfication): every time the rotary
table makes one step, an antenna reads the data coming from the tag and the
pc stores in its database all the datas.
In particular in the upper part you can control for each station the model,
number, feet, material and colour that is is production in real time. You
can also control when the mould enters in production (date and time), the
initial round of the rotary, the number of soles really producted (the
system is connectd directly to the plc of the rotary table and knows at
every step if the mould was casted or not). You can also verify if the
number of soles of left feet is the same of the right feet before to stop
the production.
In the lower part you can program the list of changes of mould: you have to
specify the initial round, the model, number, quantity, material and colour.
These datas are transmitted in real time to the pc that controls the rotary
table, so the operator is able to change the moulds following the list
programmed from the office
